Water meters are specifically engineered to prevent accelerated readings. In fact, as they wear out they will register zero consumption which then alerts the Department of Public Works crews to contact the customer and inspect the meter for potential replacement.
Since the meter readings are obtained from the remote reader located outside the house, the potential for a misread exists if there is a problem with the hard wiring to the water meter in the basement or with the remote reading devices. Misreads are extremely rare. The letter “A” following the “Current Read” on your bill indicates an actual read. To verify the reading shown on your bill, compare it to the reading on your water meter in the basement. The reading that you take (first 4 digits reading left to right) should be greater than the “Current Read” from the bill. If you subtract the bill’s “Current Read” amount from the reading you took, it will measure the amount of water consumed since the end date of the “Service Period” also shown on the bill.